총 비용
-
공임
-
부품비
-
소요 시간
-
2026. 7. 1. 작업
난이도 & 준비물
증상
2018 Camry with very low mileage (appx 38,000) and had all its required services done, suddenly had a check engine light. Less than a minute after that, "Coolant Temp High - Stop where it's safe" message popped up. Service center indicated it was a failed water pump (diagnostic codes P26CB71, U0073, U016387, U0163, P26CB). Coolant was gone. Multiple users for 2018/2019 have reported this water pump failure on r/Camry [XXX] Does not seem safe to have a car go from no problem to near catastrophic engine failure with virtually no warning INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMA
출처
이 사례는 NHTSA (미국)에서 수집한 데이터입니다.
신뢰도 2.8점(참고용) — 출처 소스의 전문성/검증구조를 기준으로 산정된 점수이며, 정확성을 보장하지 않습니다.
원문 보기 ↗토요타 캠리 다른 정비 사례
THE CAR JERKS WHEN I DO NOT ACCELERATE, WHILE MAKING A TURN, AFTER STOPPIJNG AT A RED LIGHT OR A STOP SIGN.
Hi everyone, I’m looking for some advice on a specific shifting issue with my 2007 Toyota Auris 1.4 D4D (Manual). I cannot shift from 4th gear into 3rd gear while the car is moving. It feels like hitting a physical wall, no grinding or noise, just a total lockout. Upshifting is fine 2nd to 3rd gear works perfectly. Also others gears no problem at all. From 1st to 5th to reverse. I can select 3rd gear easily when the car is stopped. The car recently sat in snow/freezing temperatures for 5 days. There is no “crunching” or grinding sound. And it was suddenly no prior symptoms. I moved my car afte
Steering wheel is becoming harder and harder to turn right or left
WHEN ACCELERATING FROM DEAD STOP IN A RIGHT HAND TURN UP-HILL CAR IS SLOW TO MOVE FORWARD REQUIRING MORE PRESSURE ON GAS PEDAL, THEN TRANSMISSION SEEMS TO BE HUNTING FOR RIGHT GEAR CAUSING A JERKY MOTION.
다른 차종의 냉각수 교환 사례
쉐보레 말리부
Temperature Guage doesn’t work, fan on motor runs, air conditioner doesn’t work when this happens and message says, “steering assist reduced, drive with caution.” Replaced temperature coolant sensor, still having problem.
차량 정보 없음
I am trying to troubleshoot a 4runner with 135k miles, auto, 3.4 V6 California emissions. This is the freeze data: PID Description Value Units 0x02 Freeze frame DTC P0420 - 0x03 Fuel system status Closed-loop, using oxygen sensor feedback to determine fuel mix - 0x04 Calculated load value 34.12 % 0x05 Engine coolant temperature 197.6 F 0x06 Short term fuel % trim - Bank 1 0.78 % 0x07 Long term fuel % trim - Bank 1 3.91 % 0x0C Engine RPM 2287 RPM 0x0D Vehicle speed 68.97 MPH 0x0F Intake air temperature 95 F So far the front and back Ox sensor was replaced and the MAF cleaned to clear a P0171 co
포드 익스플로러
Been a long day. Im not good at putting pictures on here. So ill try again. This is on my 89 year old moms ford explorer.its a 2012 she bought new. 3.5 engine. All work has been done at the local Ford dealer. 75k miles. I looked it over and decided to check the air filters and a few other things. I noticed the coolant looks pink, it should be orange. She has ever receipt from the dealer service. Its never had any work done involving coolant. Just tire rotation and oil changes. Sad to say she’s never even had them change the air filters. So im wondering why does the coolant look pink? 20260102_
현대 소나타
Coworker has a 2008 Hyundai Accent, which has overheated repeatedly, consumes a lot of coolant, and barely runs. He wants me to assist with repairing the engine, if possible. I assume by now, the head is warped or cracked, but what I am trying to determine is if the engine block in this model is iron or aluminum. If it’s iron, this can probably be repaired. If it’s aluminum, the entire engine would need to be replaced, which is more work than I would want to do.