쉐보레 말리부 수리 사례
2019년식 · 8G (2015-2023) · 1.5T 자동
총 비용
-
공임
-
부품비
-
소요 시간
-
2026. 7. 1. 작업
난이도 & 준비물
증상
Temperature Guage doesn’t work, fan on motor runs, air conditioner doesn’t work when this happens and message says, “steering assist reduced, drive with caution.” Replaced temperature coolant sensor, still having problem.
처리 내용
This could be a possible cause for your vehicles problem… MC-10210349-9999.pdf
출처
이 사례는 CarTalk (미국)에서 수집한 데이터입니다.
신뢰도 2.5점(참고용) — 출처 소스의 전문성/검증구조를 기준으로 산정된 점수이며, 정확성을 보장하지 않습니다.
원문 보기 ↗쉐보레 말리부 다른 정비 사례
94 Z28 LT1 Camaro. Intermittent stalling/starting problem. Been haunting me forever. Typically my car will start fine when it's been sitting overnight. Then I'll drive to the gym which is 2 miles away. The car will sit for the time I'm in the gym maybe an hour and then won't restart. I'll let it sit some more, crank it and eventually I'll get it started. Then it will stall at idle. I'll let it sit, get it started again and this time it will drive a short distance before sputtering on acceleration and cutting out. Sometimes it won't sputter, and instead will just instantly cut out and I'll coas
This morning my power steering stopped working and my heater and when I opened the hood there was coolant everywhere, looked like it came out of the radiator cap. The serpentine belt was off the lowest pulley and when I tried to put it back on I realized that pulley wasn't in line with the others, was not possible to put belt on. What would cause the pulley to move so far out of alignment and how can I fix it. Is this what's causing the other problems? It was below zero degrees last night and no garage.
구글링으로 수리비 긁어온 글 보니 확실히 비싸긴 비싸네요 차값이 싸니까 부품값도 싸겠지라고 생각하신 분들은 당황스러울거 같아요 아직은 초기라 그럴까요? 판매량이 늘어서 부품순환이 활성화되면 부품값은 내려가겠죠 돌아다니다가 BYD수리비 내역들 있길래 긁어옴 - 자동차 채널 뭐 첫짤은 배터리앗세이까지 나갔으면 전손처리 이해가능하긴 한데중간중간 범퍼랑 부품값보면 거의 bmw수준 아님??외장부품이 저정도까지 나올이유가 있나??그리고 공임값 존나쎈데 센터밖에 없어서 사설도 이용못한다는게 더
우회전 시 틱틱 소음, 저속 악화
다른 차종의 냉각수 교환 사례
현대 소나타
Coworker has a 2008 Hyundai Accent, which has overheated repeatedly, consumes a lot of coolant, and barely runs. He wants me to assist with repairing the engine, if possible. I assume by now, the head is warped or cracked, but what I am trying to determine is if the engine block in this model is iron or aluminum. If it’s iron, this can probably be repaired. If it’s aluminum, the entire engine would need to be replaced, which is more work than I would want to do.
포드 익스플로러
Been a long day. Im not good at putting pictures on here. So ill try again. This is on my 89 year old moms ford explorer.its a 2012 she bought new. 3.5 engine. All work has been done at the local Ford dealer. 75k miles. I looked it over and decided to check the air filters and a few other things. I noticed the coolant looks pink, it should be orange. She has ever receipt from the dealer service. Its never had any work done involving coolant. Just tire rotation and oil changes. Sad to say she’s never even had them change the air filters. So im wondering why does the coolant look pink? 20260102_
차량 정보 없음
I am trying to troubleshoot a 4runner with 135k miles, auto, 3.4 V6 California emissions. This is the freeze data: PID Description Value Units 0x02 Freeze frame DTC P0420 - 0x03 Fuel system status Closed-loop, using oxygen sensor feedback to determine fuel mix - 0x04 Calculated load value 34.12 % 0x05 Engine coolant temperature 197.6 F 0x06 Short term fuel % trim - Bank 1 0.78 % 0x07 Long term fuel % trim - Bank 1 3.91 % 0x0C Engine RPM 2287 RPM 0x0D Vehicle speed 68.97 MPH 0x0F Intake air temperature 95 F So far the front and back Ox sensor was replaced and the MAF cleaned to clear a P0171 co
차량 정보 없음
I have been chasing this overheating problem for a couple of months now, and I am thoroughly frustrated. The first issue was a hole in a short, S-shaped hose that goes from the the air bleed valve on the top of the water pump, to a metal line that goes back to the heater coil…I think. After this fix lasted for a month, I decided to change the thermostat…what a pain in the arse! After changing the thermostat didn’t fix the problem, I decided to flush the radiator. After starting the engine to run the flush through the engine, a broken three prong elbow connector cleat in the upper back of the e