토요타
정기점검미국 · NHTSA★ 신뢰도 2.8 (참고용)

토요타 캠리 수리 사례

2018년식 · ACV70 (2017-현재) · 2.5 자동

총 비용

-

공임

-

부품비

-

소요 시간

-

2026. 7. 1. 작업

난이도 & 준비물

난이도 쉬움⏱ 예상 60~120🔧 전용 진단기

증상

The contact owns a 2018 Toyota Camry. The contact stated that while driving at an undisclosed speed, the vehicle veered into another lane, but the lane departure system did not alert him. The lane departure warning light was illuminated. The dealer was made aware of the failure and informed the contact that he would need to pay for the diagnostic test and repair. The vehicle was not diagnosed nor repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 13,400.

출처

이 사례는 NHTSA (미국)에서 수집한 데이터입니다.

신뢰도 2.8점(참고용) — 출처 소스의 전문성/검증구조를 기준으로 산정된 점수이며, 정확성을 보장하지 않습니다.

원문 보기 ↗

다른 차종의 정기점검 사례

차량 정보 없음

Hello! I have not driven my car for a month and now have this noise. It is a 2016 V Jetta and normally in great shape. The noise is in the background and sounds like something soft is rubbing against something. It picks up at 10 mi/hr or so and then stays on…Thank you! https://global.discourse-cdn.com/cartalk/original/3X/3/f/3f6ae6628ea80cf8d6b1899d0b2392d868545516.mp3

차량 정보 없음

i looked in my hood and noticed this serpentine belt. does it need replacement? it’s not making any squeeking noises car runs fine for being about 16 years old. IMG_4074 1920×2560 686 KB

닛산

닛산 알티마

Power seat - Whenever vehicle is started or shut off and the seat slides forward of back, the power seat makes an annoying, obnoxious noise… I thought something was stuck in the track but now I think it’s the motor going out. Guy at the local dealership said it just needed grease. He appears to be incorrect. Any thoughts? Thoughts?

차량 정보 없음

A buddy and I were trying to replace his right front wheel hub, on his 2008 Chevy Impala LTZ. He described the engine size as 3900, I would think that means 3.9 liter, although I didn’t know there is a 3.9, I only know of the 3.8 liter and 3,1 Liter. One of the mounting bolts is so tight that the socket would not keep a grip on the bolt head, no matter how hard we tried to force the socket onto the bolt head. We had tapped on it as best we could with a hammer and metal rod, we heated the area with a torch, no luck. Of course, very little access to this bolt head, so impossible to use an impact