토요타
정기점검미국 · NHTSA★ 신뢰도 2.8 (참고용)

토요타 캠리 수리 사례

2018년식 · ACV70 (2017-현재) · 2.5 자동

총 비용

-

공임

-

부품비

-

소요 시간

-

2026. 7. 1. 작업

난이도 & 준비물

난이도 쉬움⏱ 예상 60~120🔧 전용 진단기

증상

Break booster vacuum pump needs to be replaced per the diagnostic at the Toyota dealership. My car would not completely start when I was trying to turn it on. The break pad became stiff, unable to press down and a warning message stated “low breaking power”, therefore the car would not turn on and it became not drivable. If this were to happen while I was driving on the road, not only would it put myself in a lot of danger but others as well due to not being able to break. Even though it is not a part of the 2018 Camry recall batch, it is the exact same issue, therefore it is definitely a ma

출처

이 사례는 NHTSA (미국)에서 수집한 데이터입니다.

신뢰도 2.8점(참고용) — 출처 소스의 전문성/검증구조를 기준으로 산정된 점수이며, 정확성을 보장하지 않습니다.

원문 보기 ↗

다른 차종의 정기점검 사례

차량 정보 없음

Hello! I have not driven my car for a month and now have this noise. It is a 2016 V Jetta and normally in great shape. The noise is in the background and sounds like something soft is rubbing against something. It picks up at 10 mi/hr or so and then stays on…Thank you! https://global.discourse-cdn.com/cartalk/original/3X/3/f/3f6ae6628ea80cf8d6b1899d0b2392d868545516.mp3

차량 정보 없음

i looked in my hood and noticed this serpentine belt. does it need replacement? it’s not making any squeeking noises car runs fine for being about 16 years old. IMG_4074 1920×2560 686 KB

닛산

닛산 알티마

Power seat - Whenever vehicle is started or shut off and the seat slides forward of back, the power seat makes an annoying, obnoxious noise… I thought something was stuck in the track but now I think it’s the motor going out. Guy at the local dealership said it just needed grease. He appears to be incorrect. Any thoughts? Thoughts?

차량 정보 없음

A buddy and I were trying to replace his right front wheel hub, on his 2008 Chevy Impala LTZ. He described the engine size as 3900, I would think that means 3.9 liter, although I didn’t know there is a 3.9, I only know of the 3.8 liter and 3,1 Liter. One of the mounting bolts is so tight that the socket would not keep a grip on the bolt head, no matter how hard we tried to force the socket onto the bolt head. We had tapped on it as best we could with a hammer and metal rod, we heated the area with a torch, no luck. Of course, very little access to this bolt head, so impossible to use an impact