머플러 교환 수리 사례
총 비용
-
공임
-
부품비
-
소요 시간
-
2026. 6. 30. 작업
난이도 & 준비물
증상
What Can I Learn From Exhaust Manifold Temps?
처리 내용
Generally when an engine runs, if it is running lean, it will run hotter. If an engine is running rich, it will run cooler. Each individual cylinder is no different. After an engine is completely warmed up, if one measures each cylinder at the same basic place on the exhaust manifold, you can get an idea of which cylinder is running lean and which is running rich in comparison to each other. On the GM LT1 (Gen-II Small Block) ECU, there is a table in the ECU called the Individual Cylinder Fuel Trim Multiplier . I don't know if every ECU has one, but will assume for the sake of argument that they have something like this. This table allows for the fine adjustment of each cylinder to get them working at the same levels. To factor this and get the table adjusted correctly, you need to take the temperature of each cylinder at the exhaust manifold. To perform the operation, you take the temperature of each cylinder (as you stated you did in your question), then make adjustments in the table
출처
이 사례는 Stack Exchange에서 수집한 데이터입니다.
신뢰도 2.5점(참고용) — 출처 소스의 전문성/검증구조를 기준으로 산정된 점수이며, 정확성을 보장하지 않습니다.
원문 보기 ↗다른 차종의 머플러 교환 사례
차량 정보 없음
My Pilot is lighting up a catalytic converter code on the dashboard. My Boch Honda dealer service is quoting $1,037 for the replacement part and more than $600 for the labor. Does that make any sense? The car has 180,000 miles on it. Should I just go with non-Honda parts?
토요타 캠리
AN EMERGENCY MESSAGE CAME ON TELLING ME MY BRAKES WERE LOSING POWER BAND I NEEDED TO PULL OVER TO A SAFE AREA. I WAS ON THE FREEWAY! I COULD NOT PUSH DOWN. I HAD TO USE THE PARKING BREAK AND GO INTO A LOWER GEAR TO GET TO THE SHOULDER THEN MY CAR CAME TO A STOP IN THE CROSSWALK OF THE FREEWAY EXIT. VACUUM PUMP STOPPED WORKING. WENT IN TO REPLACE IT AND THE BACKSIDE IS DECENTIGRATED INTO THE MOTOR. NEEDS CAMSHAFT ASSEMBLY/EXHAUST REPLACED, INVESTIGATE THE MOTOR TO LOOK FOR PIECES SO THEY DON'T DAMAGE THE MOTOR, NO GEAR AT THE END OF THE VACUUM PUMP, IT HAS GONE DOWN NOT THE MOTOR
차량 정보 없음
I drive a 2004 Ford Ranger, which I’ve had for the life of the truck. For a few years, I’ve had the CEL on more often than not, usually for codes related to oxygen sensors and cat converter. I’ve taken the truck to a couple of shops and had O2 sensors replaced (repeatedly), but the CEL has come back on within a few days. I’m not at all experienced with auto-work, but I’ve been trying to pick up some new skills (in the interest of not going broke). So, aside from the shops doing their work, I’ve personally replaced a couple of O2 sensors, one catalytic converter, fuel filter, plugs, etc. Betwee
차량 정보 없음
My 2005 Buick Century with 353k miles gets a recurring P0420 code, catalytic converter operating below efficiency level. Twice this year, I tried using Cataclean, but with no success. I noticed a small hole in my muffler at the seam. Could a lack of exhaust back pressure cause the CC to operate inefficiently or improperly? Can anyone recommend a catalytic converter cleaner? Or, is it all snake oil?