정기점검 수리 사례
총 비용
-
공임
-
부품비
-
소요 시간
-
2026. 6. 30. 작업
난이도 & 준비물
증상
Seized engine due to being run without oil
처리 내용
Yes, it could go that far ... it really depends on the condition of the oil and the engine when the oil dropped, but yes it absolutely could go that far. As a side note ... If she was able to get it 40 miles, that engine is completely toast and will require at a minimum, a complete rebuild. The easier bet here would be to just get a replacement engine from a reputable junk yard. A complete rebuild would cost too much for reconditioning parts. A new engine would be even more expensive.
출처
이 사례는 Stack Exchange에서 수집한 데이터입니다.
신뢰도 2.5점(참고용) — 출처 소스의 전문성/검증구조를 기준으로 산정된 점수이며, 정확성을 보장하지 않습니다.
원문 보기 ↗다른 차종의 정기점검 사례
차량 정보 없음
Hello! I have not driven my car for a month and now have this noise. It is a 2016 V Jetta and normally in great shape. The noise is in the background and sounds like something soft is rubbing against something. It picks up at 10 mi/hr or so and then stays on…Thank you! https://global.discourse-cdn.com/cartalk/original/3X/3/f/3f6ae6628ea80cf8d6b1899d0b2392d868545516.mp3
차량 정보 없음
i looked in my hood and noticed this serpentine belt. does it need replacement? it’s not making any squeeking noises car runs fine for being about 16 years old. IMG_4074 1920×2560 686 KB
닛산 알티마
Power seat - Whenever vehicle is started or shut off and the seat slides forward of back, the power seat makes an annoying, obnoxious noise… I thought something was stuck in the track but now I think it’s the motor going out. Guy at the local dealership said it just needed grease. He appears to be incorrect. Any thoughts? Thoughts?
차량 정보 없음
A buddy and I were trying to replace his right front wheel hub, on his 2008 Chevy Impala LTZ. He described the engine size as 3900, I would think that means 3.9 liter, although I didn’t know there is a 3.9, I only know of the 3.8 liter and 3,1 Liter. One of the mounting bolts is so tight that the socket would not keep a grip on the bolt head, no matter how hard we tried to force the socket onto the bolt head. We had tapped on it as best we could with a hammer and metal rod, we heated the area with a torch, no luck. Of course, very little access to this bolt head, so impossible to use an impact