현대 아반떼 수리 사례
2010년식 · MD (2010-2015) · 1.6 GDi 수동
총 비용
-
공임
-
부품비
-
소요 시간
-
2026. 7. 1. 작업
난이도 & 준비물
증상
Hello! I have a 2010 Hyundai Elantra with 185,000 miles on it. Things are tight financially right now and so I’ve been trying to get this car to last as long as possible before investing in a new one. A year or two ago, a mechanic told me that I needed to get a bunch of work done on my car. We did some of it but saved the front struts and CV axles and are now trying to decide if it’s worth it to spend the money on this. So, I’m asking for some advice from all of you. Is it worth spending the money? Will my car fall apart if I ignore these repairs? I need to get at least another year out of it
처리 내용
Are you getting any clicking noises when making tight turns, like turning into a parking spot?? Are you getting a weird vibration under harder acceleration, but goes away as soon as you ease up on the throttle?? If yes to either, then replace the axle(s) soon… Why did they suggest/recommend strut replacement??
출처
이 사례는 CarTalk (미국)에서 수집한 데이터입니다.
신뢰도 2.5점(참고용) — 출처 소스의 전문성/검증구조를 기준으로 산정된 점수이며, 정확성을 보장하지 않습니다.
원문 보기 ↗현대 아반떼 다른 정비 사례
다른 차종의 드라이브샤프트 교환 사례
혼다 CR-V
I drive a 2014 Honda CR-V. My steering wheel vibrates whenever my car speed is between 30-40 mph. Once past 40 mph, the vibration stops completely. While most explanation mentions about bad CV joint, motor mount, loose lug nuts, unbalanced tires, stuck brake caliper, etc but it doesn’t address the issue as to why it only vibrates between 30-40 mph and not before or after. It is very steady even from 60 mph and beyond. Any idea what is the problem?
혼다 어코드
2020 Honda Accord. I’m now realizing that the lower ball joints use self locking clinch nuts. Have never heard of clinch nuts before. Anyways the service information says to replace them. This is with regards to the lower three nuts that goes onto the studs, as opposed to castle nut that goes on top under the cv axle. See lots of people on youtube doing repairs which requires removing these nuts, and they go ahead and use the same old rusty nuts right back on. image 667×557 32.8 KB Looking online at this type of self locking technology. It is mostly used in sheet metal. A hole is drilled into
차량 정보 없음
Throw out bearing, input shaft bearing, or drive shaft support bearing?
차량 정보 없음
How to isolate a wheel bearing or a CV axle noise?