정기점검 수리 사례
총 비용
-
공임
-
부품비
-
소요 시간
-
2026. 6. 30. 작업
난이도 & 준비물
증상
Honda Odyssey engine cut out
처리 내용
I won't address the stalling - that COULD have had any of a very wide variety of causes. That loud whining noise, though - that was just when you had the key turned to "Start", right? And it quit immediately when you released the key? If so, then it would have been the starter motor's "Bendix" (overrunning clutch for the starter drive gear) spinning... which would call for replacement of the Bendix. There's a remote possibility, too, that the ring gear on the flex plate has a broken tooth or two - that'd be made evident by a history of that sort of thing happening, but only about once per hundred starts (the ring gear has a LOT of teeth, so the chances of accidentally landing on the broken one / two are pretty slim). The stalling... VERY hard to tell from here. Got a "Check Engine" light?
출처
이 사례는 Stack Exchange에서 수집한 데이터입니다.
신뢰도 2.5점(참고용) — 출처 소스의 전문성/검증구조를 기준으로 산정된 점수이며, 정확성을 보장하지 않습니다.
원문 보기 ↗다른 차종의 정기점검 사례
차량 정보 없음
Hello! I have not driven my car for a month and now have this noise. It is a 2016 V Jetta and normally in great shape. The noise is in the background and sounds like something soft is rubbing against something. It picks up at 10 mi/hr or so and then stays on…Thank you! https://global.discourse-cdn.com/cartalk/original/3X/3/f/3f6ae6628ea80cf8d6b1899d0b2392d868545516.mp3
차량 정보 없음
i looked in my hood and noticed this serpentine belt. does it need replacement? it’s not making any squeeking noises car runs fine for being about 16 years old. IMG_4074 1920×2560 686 KB
닛산 알티마
Power seat - Whenever vehicle is started or shut off and the seat slides forward of back, the power seat makes an annoying, obnoxious noise… I thought something was stuck in the track but now I think it’s the motor going out. Guy at the local dealership said it just needed grease. He appears to be incorrect. Any thoughts? Thoughts?
차량 정보 없음
A buddy and I were trying to replace his right front wheel hub, on his 2008 Chevy Impala LTZ. He described the engine size as 3900, I would think that means 3.9 liter, although I didn’t know there is a 3.9, I only know of the 3.8 liter and 3,1 Liter. One of the mounting bolts is so tight that the socket would not keep a grip on the bolt head, no matter how hard we tried to force the socket onto the bolt head. We had tapped on it as best we could with a hammer and metal rod, we heated the area with a torch, no luck. Of course, very little access to this bolt head, so impossible to use an impact