제네시스
브레이크 디스크 교환

제네시스 G70 수리 사례

2019년식 · IK (2017-현재) · 2.0T 자동

총 비용

265,000원

공임

70,000원

부품비

195,000원

소요 시간

90분

2026. 3. 28. 작업

난이도 & 준비물

난이도 보통⏱ 예상 90~180🔧 잭스탠드🔧 특수공구

증상

고속 제동 시 핸들 진동, 브레이크 페달 떨림

진단

전륜 브레이크 디스크 열변형 심각 (런아웃 0.09mm). 패드 잔량 4mm.

처리 내용

전륜 브레이크 디스크 및 패드 세트 교환. 캘리퍼 피스톤 상태 양호.

M

MechanicHub 데이터베이스

프로필 →

이 정비사에게 직접 문의하기

로그인하면 연락처를 확인할 수 있어요

로그인 후 보기

제네시스 G70 다른 정비 사례

2.0T 자동

상하이산 구 모델Y RWD 5699입니다. (제네시스 GV60도 운용중이니까 소위말하는 까/빠 한쪽편아닙니다...) 23년 출고해서 지금까지 여름, 겨울 공조기는 아무 문제없이 잘 타고다니다가 갑자기 몇일전에 a447 코드 뜨면서 에어컨 바람이 나왔다 안나왔다가하는 증상 발생했습니다. 계속 안나왔던건 아니고 그날만 딱 2번 에어컨 가동중 갑자기 미지근한 바람이 나오면서 자세히보니 미지근한 바람나올때 당연하지만 외부에서 컴프레셔 가동 소리 안들리는 상황입니다. 바로 정비예약하고 서비스센터 방문해서 점검하니까 컴프레셔 통신이상이라고 들었고 컴프레셔 앗세이 교체했고... 현기차에서 요즘 나오는 신형 냉매 R1234 때문에 부식 문제는 테슬라는 없다고합니다. 대부분 테슬라 공조기 관련 고장은 컴프레셔 고장/불량, 매니폴드고장, 냉매 누설(크랙)입니다. 요즘 흔히 말하는 현기차에서 나오는 신형 냉매 R1234가 공조기라인 부식을 시킨다거나 냉매자체가 고장을 유발하거나 그런건 아닌것 같습니다. 만약 보증끝나서 컴프레셔, 매니폴드, 공조라인, 냉매, 공임비 다합치면 약 400만원입니다 ㅋㅋㅋ 21년식 모델Y는 매니폴드, 컴프레셔 이슈가 있긴 있었는데 그 이후 어떻게 됬는

2.0T 자동

신차고 중고고 기름값이 비싸서 무조건 기피 대상일듯합니다 하이브리드나 전기차가 날개돗힌듯이 팔릴듯...

브레이크 패드 교환2.0T 자동

브레이크 소음 + 패드 경고

다른 차종의 브레이크 디스크 교환 사례

차량 정보 없음

I just hand my 1995 Jeep Grande Cherokee 4.0L straight 6 automatic in for tune-up (rotor, cap, wires, plugs, filters oil etc) and trans fluid service at special jeep repair shop. Also had the motor mounts and front suspension arms with bushing replaced four days after the tune up and trans service. Now after the tune-up and trans service was complete and prior to replacing the motor mounts I immediately notice more pronounced vibration in the steering wheel when stopped at a light. Take it out of gear and place in neutral while stopped at the light and it gets better but not totally gone. The

차량 정보 없음

Good afternoon all. My car, a 1997 Toyota Corolla has developed a problem I’m hoping maybe someone can help me figure out. Lately I’ve had a plethora of work done to the car. I’ve had the gas tank, fuel pump, all four struts, main oil seal, plugs, wires, cap, rotor, transmission fluid/filter, motor oil/filter etc, all replaced. The car actually runs pretty good, except, after having the main oil crankshaft oil seal replaced, the car has developed a problem. It feels like I got bad gas but I don’t think that’s the problem. If I press too hard on the accelerator, the car wants to stall. If I tak

포드

포드 F-150

I found out today I need to do the brakes on my f150. I went amd got pads and rotors before the ford dealer closed. But when I started i realized I should probably replace the calipers too. So I have a question, should l wait until Monday and get motorcraft from the dealer or go pick up some carquest premium ones from advance auto? I can live without the truck for a few days but id like to finish it up too. Im guessing motorcraft is reman like the carquest. What do you all think?

토요타

토요타 캠리

IF YOU SLOW TO A ROLL THEN TRY TO ACCELERATE, IT JERKS REAL BAD LIKE IT DOES NOT KNOW WHAT GEAR TO GO INTO. TAPPING FROM THE ENGINE BAY THAT COMES AND GOES. THE BRAKE ASSIST FEATURE CAUSE MY ROTORS TO GET WARPED RIGHT AFTER REPLACING THEM. LANE KEEPING ASSIST WILL YANK YOU OVER INTO A TURNING LANE IF YOU AREN'T SUPER CAREFUL.