엔진오일 교환PistonHeads★ 신뢰도 4.1 (높음)

르노코리아 QM6 수리 사례

J63 (2016-현재) · 1.3T AWD

2026. 10. 5. 작업

난이도 & 준비물

증상

Scrolling on Instagram, I spotted this videohttps://www.instagram.com/reel/Dd1-9nvNB-_/?stkn=M...They had to separate the body and drivetrain of an Aston Martin Rapide because a nut had come loose on the wiper mechanism. Massive bill for a simple fix. It got me think back to my dads mk3 mondeo which was meant to be a bumper off job to swap a headlight bulb. I think the 2nd gen Renault Megane was the same. What else is there out there that requires a degree in engineering, a 4 poster lift and a snap on lorry full of tools to change a fuse or something equally as easy?

처리 내용

CT05 Nose Cone said: I remember seeing that the rear screen needs to be removed to replace the high level brake light on a Bentley ContinentalNot quite the same level but a few years back I had a mk5 golf and the high level break light was set into the spoilerIt was prone to failing and then you had the conundrum of whether it was an MOT failureTo replace it required removing the spoiler which apparently was welded / glued on so needed cutting off and would likely snap in the process. No one was interested in the job apart from main dealers quoting for a new spoiler and paint job. There was a hack that involved smashing the light out instead and then it could be replaced externally. With MOT approaching and armed with a hammer and screwdriver I went for it not knowing if it would work or if I would end up with a hole in my spoiler where the light used to be.Took about 2 hours in total most of which was spent fiddling with the connector cable - once the light was removed it turned out there was a small 1 inch square in the spoiler with sharp edges where the cable came through. Added to that there was hardly any slack in the cable despite it sitting in the void of the spoiler. So 2 hours of hooking fingers around the connector cable inside the little 1 inch sharp edged hole to avoid pushing the cable into the spoiler void and trying to connect it to the rear of the light with no space and no visibility.Definitely a design fail